#INFOSWMM

How to Extract the Engine SWMM5 Calculated Slope in InfoSWMM

How to Extract the Engine SWMM5 Calculated Slope in InfoSWMM. The slope is a calculated value in SWMM5.

Please see this other blog for the slope calculations in SWMM5

https://swmm5.org/2011/01/20/swmm-5-slope-rules-2/

Step 1 – Run the model

Step 2 – Load the Conduit Summary Table

Step 3 – The slope for an individual link is shown in the Attribute Browser in the Output section (slope is a fraction)

Step 4 – Copy the slope (percent slope) from the Conduit Summary Table to the Conduit Information Table

Step 5 – The slope can now be used outside of the SWMM5 engine to find adverse slopes.

Privileged and Confidential Communication: This electronic mail communication and any documents included hereto may contain confidential and privileged material for the sole use of the intended recipient(s) named above. If you are not the intended recipient (or authorized to receive for the recipient) of this message, any review, use, distribution or disclosure by you or others is strictly prohibited. Please contact the sender by reply email and delete and/or destroy the accompanying message.

Categories: #INFOSWMM

Leave a Reply