#INFOSEWER – Page 18 – EPASWMM5, Autodesk Innovyze InfoWorks ICM SWMM & ICM InfoWorks, InfoSWMM , InfoDrainage, SWMM5+

InfoSewer Flow Attenuation Sensitivity

July 26, 2013December 23, 2015 Storm/Sewer Modeler with a 45 yr association with EPASWMM. Now at Autodesk supporting InfoWorks ICM_SWMM Founder http://robertdickinson.org, Chair/TAC at http://CIMM.ORG No Comments

InfoSewer Flow Attenuation Sensitivity

The three Run manager parameters, Maximum Number of Segments, Minimum Travel Distance and the Minimum Travel Distance in InfoSewer and H2OMAP Sewer affect the shape and flow attenuation of the flow in a link. The effect of using the flow attenuation is to reduce the peak … Read the rest

#INFOSEWER, InfoSewer

InfoSewer Inflow Control for a PUMP

You can control the pumps in InfoSewer and H2OMap Sewer by using a Pump Control which will control the pump based on:

1. Volume

2. Level

3. Discharge

4. Inflow

5. Time

If you use a By Inflow control the pump speed of the … Read the rest

#INFOSEWER, InfoSewer

Two Pass InfoSewer Solution

June 24, 2013December 23, 2015 Storm/Sewer Modeler with a 45 yr association with EPASWMM. Now at Autodesk supporting InfoWorks ICM_SWMM Founder http://robertdickinson.org, Chair/TAC at http://CIMM.ORG No Comments

Two Pass InfoSewer Solution

The d/D you are Mapping is from the 1^st pass or the solution in which the manhole loads are calculated and the program estimates the flow in the links – the flow gives the value of d/D which you are mapping.

The HGL plot is

… Read the rest

#INFOSEWER, InfoSewer