Rain Barrel LID Control for InfoSWMM and InfoSWMM Sustain w/ SWMM5

This is an introduction along with images of the LID Control and data require3ments in InfoSWMM. Every InfoSWMM Control uses from one to 5 layers of data - each with different data requirements. You can use the Siting Manger … Read the rest

Green Roof LID’s in InfoSWMM Sustain and ICM SuDS

… Read the rest

LID Utilization in SWMM5 and InfoSWMM w/ Sustain

Utilizing LID controls within a project is a two phase process that:

1. creates a set of scale-independent LID controls that can be deployed throughout the study area,

2. assigns any desired mix and sizing of these controls to selected Subcatchments.

Bear … Read the rest

Run InfoSWMM Sustain for ICM SuDS and SWMM 5 LID’s

The Optimization takes place after either you create the LID Candidates using the Siting Manager, Createthe LID's yourself on the Map or import the LID's from InfoSWMM. The optimizer as shown in the following image Minimizes Cost and Maximizes the … Read the rest

LID Output Tabular Reports (Time Series Report) for InfoSWMM and InfoSWMM Sustain

The LID Report in Output Report Manager lists the LID pathway values for individual timesteps for each LID Control on every Subcatchment for these parameters:

1. Surface Inflow normalized to the area of the LID Control in units … Read the rest

LID Graphs n InfoSWMM and InfoSWMM Sustain w/ SWMM5 LID

The LID Graphs in Output Report Manager graphs the LID pathway values for individual timesteps for each LID Control on every Subcatchment for these parameters:

1. Surface Inflow normalized to the area of the LID Control in units of inches/hour … Read the rest

Bio-Retention in InfoSWMM and InfoSWMM Sustain w/ SWMM5 LID

… Read the rest

LID Placement for Controls in InfoSWMM and SWMM5 w/ InfoSWMM Sustain

There are two different approaches for placing LID controls within a Subcatchment:

• place one or more controls in an existing Subcatchment that will displace an equal amount of non-LID area from the Subcatchment
• create a new Subcatchment devoted entirely

LID Controls in InfoSWMM and InfoSWMM Sustain – Introduction

LID Controls are low impact development practices designed to capture surface runoff and provide some combination of detention, infiltration, and evapotranspiration to it. They are considered as properties of a given Subcatchment, similar to how Aquifers and Snow Packs are treated. … Read the rest

SuDS in InfoWorks ICM

In InfoWorks ICM 6.5 and later the SWMM 5 LID Controls were added to the Subcatchment Grid of ICM. Here is a copy of the ICM Help File. The LID Controls are entered in the Subcatchment Grid (1), in the SuDS or LID Tab (2), it … Read the rest